Demo Methods Download

All the Demo Methods described in the VENUS one Programmer's Manual can be downloaded from this section. This offers you the chance to, in addition to the manual, directly see what has been programmed and how it works in simulation mode or on your HAMILTON instrument.

The number in brackets gives you the chapter of Programmer's Manual, where the specific method is described.

&nb

IMPORTANT: Depending on the settings during the software installation, not all necessary labware may be activated. To see how to activate needed labware, click here.
Each demo method zip file contains a list showing the used labware in this method.

LLD Check, zip, 560.1 KB

This method shows how to speed up the use of the cLLD detection with 1000ul Channels (11.8).

LiquidHandling, zip, 567.43 KB

This method supports how to programm an own error handling with 1000ul Channels (11.11.2).

AddSamplesAndBufferToPlate, zip, 570.99 KB

This method describes using the action editor with 1000ul channels (12.2).

OnePlateToPlatePipette, zip, 563.28 KB

This methods describes how to copy a plate using SMART Steps with 1000ul Channels (12.3).

OnePlateToPlatePipetteSingleSteps, zip, 565.35 KB

This methods describes how to copy a plate using SINGLE Steps with 1000ul Channels (12.4).

TubesToPlatePipette, zip, 563.48 KB

This methods copies tubes to plates using SMART Steps with 1000 ul Channels (12.5).

HitPicking, zip, 574.42 KB

This method describes how to programm a method with results from a excelfile with 1000ul Channels (12.6).

Demo96To384, zip, 569.63 KB

This method copies four 96 well plates into a 384 well plate with CO-RE 96 Probe Head (12.7).

Demo384To1536, zip, 592.87 KB

This method supports the use of the CO-RE 384 Probe Head (12.8).

NanoPipettor, zip, 570.07 KB

This method supports the use of the Nano pipettor (12.9).

DemoSubmethod, zip, 573.67 KB

This method describes how to build sub-methods and how to invoke a sub-method library for a particular funktion with 1000ul Channels (12.10).

DemoiSwap, zip, 570.03 KB

This method describes the use of the iSWAP with 1000ul Channels (15.3).

TubeGripper, zip, 563.06 KB

This method supports the use of the Tube Gripper with 1000ul Channels (16.1).

DemoCo-ReGrip, zip, 564.06 KB

This method describes the use of the CO-RE Gripper plate handler and the use of arrays with 1000ul Channels (17.3).

DemoBarcodeReadingWithCoRe, zip, 560.52 KB

This method shows how to read a platebarcode with using the CO-RE Gripper with 1000ul Channels (17.7.2).

DemoWashStation, zip, 558.5 KB

This method supports the use of the CR Needle Wash Station with 1000ul Channels (18.3).

DemoTCC, zip, 571.65 KB

This method supports the use of the TCC with 1000ul Channels (22.2).

DemoBVS, zip, 573.03 KB

This method describes the use of the BVS Vacuum System with 1000ul Channels (23.3).

Last updated: 24.09.2008